Installation Manual

Hurry CALL Now

8100635998

Install Auto Pump Controller & Forget "OVERFLOW"

FOLLOW THE DIAGRAM FOR EASY INSTALLATION

INSTALLATION INSTRUCTION MANUAL

Product Installation is Very Easy just Follow the given Instruction below:

1. Takeout the Product & the Instruction Manual.

  1. Get Familiar with the Product. Big RED/BLACK Switch on the left side (For Auto & Manual Operation). On the top of Product there are 6 Sensor wires for Sensor Probe Connection and remaining 3 Wires for Pump Automatic Operation Connection.

How to Install the Product: PUMP AUTOMATIC DEVICE CONNECTION

1.Cut off the power supply for pump starter / switch prior to start the installation.

  1. Hang the Automatic Pump Controller near Pump Starter / Switch.
  2. Connect P+ with Phase, Then Pump+ connect with Pump +ve power input supply towards Pump. Then N(-) with Neutral.

FOR OHT TANK SENSOR CONNECTION

Fix the Sensor Probe inside OHT (Over Head Tank) in 3 different Levels, to fix OHT High sensor probe 5 Inches below overflow pipe. OHT Low sensor probe 10 Inches above from bottom and OHT Ground sensor probe just above 8 Inches from bottom.

FOR RESERVOIR / UNDERGROUND TANK SENSOR CONNECTION

Fix the Sensor Probe inside Reservoir Tank in 3 Different Levels, To fix RES GROUND sensor probe 4 Inches above suction pipe, RES LOW sensor probe 6 Inches above suction pipe & RES HIGH sensor probe 10 Inches above suction pipe.

CONTROLLER CONNECTION

Bring all 6 sensor wires from OHT &RES Tank (which is connected to the sensor probes as shown in diagram) & connect accordingly. & before starting main switch, be sure AUTO/MANUAL Switch should be in auto position.

(NOTE:- Keep Pump Starter/Switch тАШONтАЩ all the time, when water pump controller is in Auto position) & Manual Switch is for Emergency purpose only. If you found any difficulty during Installation, Feel free to contact our Dealer, Distributor, Reseller or Company Representative.